Certifications and compliances

• Class I, Divisions 1 & 2, Groups B*, C, D
• Class II, Division 1, Groups E, F, G
• Class II, Division 2, Groups F, G
• Class III
• UL standard: UL1203
  
• CSA standard: C22.2 No. 30
• NEMA/EEMAC 3, 7B*CD, 9EFG, 12

*Single-gang – 1P, 2P, 3W, 4W (20A): Factory sealed for Class I, Divisions 1 & 2, Groups B, C, D – no seals required.  Single-gang – 1P (30A), 2P (30A), 3P (10A, 15A), 3W (30A): Class I, Division 1, Groups C, D and Class I, Division 2, Groups B, C, D – seal within 18".  Class I, Division 1, Group B – add suffix GB and install seals within 1-1/2” of conduit openings for self-certification to UL standard.

Two-gang – 20A: Factory sealed for Class I, Division 1, Groups C, D and Class I, Division 2, Groups B, C, D – no seals required.  Class I, Division 1, Group B – add suffix GB suffix and install seals within 1-1/2” of conduit openings for self-certification to UL standard.  Two-gang – 30A: Class I, Division 1, Groups C, D and Class I, Division 2, Groups B, C, D – seal within 18".  Class I, Division 1, Group B – add suffix GB and install seals within 1-1/2” of conduit openings for self-certification to UL standard. 

• Factory sealed devices eliminate external seals, reduce installation problems, lower installation costs and improve safety
• Are used with general purpose snap and pushbutton type switches
• Standard neoprene covers for front operated pushbuttons; prevents accumulation of dirt and entrance of water around operating shafts
• Mounting lugs and taper tapped hubs with integral bushings
• Large machine screws for fastening covers to bodies
• Lockout provisions on front operated pushbutton (marked "STOP" and "OFF") and selector switch covers
• Lockout hole for padlock having 1/4" hasp is provided when used with covers for front lever and side rocker type operation
• Close tolerances in machining of wide, mating flanges and journalled shafts and bearings for front button operation, produces flametightness of enclosure joints
• On enclosures with front lever and side rocker type operating handles, threaded type shafts and bushings are used to ensure flametightness
• Dead end (EFS or EDS) or through feed (EFSC or EDSC) hubs – 1/2" to 1" sizes

• Bodies and covers – Feraloy iron alloy (standard); copper-free aluminum (optional)
• Shafts – stainless steel
• Shaft bushings – stainless steel